etcher: Etcher claims the freshly formatted target drive is the source drive and wont let me select it

  • Etcher version: 1.18.4
  • Operating system and architecture: macOS Ventura 13.3.1 on Intel iMac Pro
  • Image flashed: self-built installation ISO for NixOS
  • What do you think should have happened: I should have been able to select the thumb drive as my target drive to flash the ISO
  • What happened: Etcher shows a blue “Source drive” label next to the thumb drive and disabled the check box to select it as the target
  • Do you see any meaningful error information in the DevTools? no

The target selection dialog:

Screenshot 2023-04-16 at 16 15 12

The location of the image:

Screenshot 2023-04-16 at 16 19 55

Unusual things about the system:

  • The boot drive is not the internal drive but an SSD connected via USB because the internal drive is flaky. The boot drive is disk6 according to Disk Utility
    • disk7 is the APFS container
    • disk7s1s1 is the macOS volume
      • This is where the ISO resides that I want to flash
  • The internal drive that is not used for booting is disk0 ⚠️ Etcher misidentified this drive as the System drive
  • The thumb drive got assigned disk2
    • There are no files on the thumb drive, it has just been formated and is empty

About this issue

  • Original URL
  • State: open
  • Created 4 years ago
  • Comments: 16 (4 by maintainers)

Most upvoted comments

Ran into this issue today. Tried writing a 1TB image stored on an external drive to a target device - both devices connected via a thunderbolt dock. I suspect it has something to do with the USB bus hierarchy. For the record, I’m using the following:

  • Mac Mini M4
  • Caldigit Thunderbolt4 Dock
    • Onboard SDXC Port
    • Sony MRW-G2 Thunderbolt SD Card Reader
  • 1TB MicroSD

What doesn’t work:

  • Target Drive in onboard SD Card reader with source image on external drive (Same Source)
  • Target Drive through an external SD Card with source image on separate external drive (Same Source)

What does work:

  • Target drive on a completely separate USB bus than the thunderbolt dock’s. Attaching external SD Card reader directly to mac mini thunderbolt port.

There’s probably some logic somewhere that assumes drives under a common hub are of the same source.

Screenshot 2025-01-08 at 9 33 31 AM Screenshot 2025-01-08 at 9 32 39 AM