WLED: WLED and Ubiquiti U7 pro incompatibility/problem?

https://github.com/user-attachments/assets/ff5bfc1e-2d54-4b5f-9a36-41c9703a4be3

What happened?

Im runing WLED on ESP32 and its been running good for guite some time. Just now updated my old asus wifi to Ubiquiti U7 pro. There has been reports that there is issues whit IoT devises so this problem that im having is moastlikely something to do whit Ubiquiti U7 pro not just WLED. So the bug it self is that when ESP32 WLED is connected to Ubiquiti U7 PRO WLED will not respond to commands at all and will say connection to light failed. it will be unresponssive for some seconds untill it will be normal for about 10s and then it will hapen again in a loop. Also if WLED devise is connected to Ubiquiti U7 PRO all effects will stop and resume after the frize. This will loop also. Video off the problem

Any ideas what could be causing this?

To Reproduce Bug

Ubiquiti U7 PRO and ESP32 connected. Running a effect will make the problem easy to see but you will not be able to controll anything when when the device gets stuck

Expected Behavior

effect should not stop and conrolling the light should be possible

Install Method

Binary from WLED.me

What version of WLED?

Nightly Release 20250124 and WLED 0.14.0 “Hoshi” have the same issue

Which microcontroller/board are you seeing the problem on?

ESP32

Relevant log/trace output


Anything else?

Image

Code of Conduct

  • I agree to follow this project’s Code of Conduct

About this issue

  • Original URL
  • State: closed
  • Created 2 years ago
  • Comments: 24 (3 by maintainers)

Most upvoted comments

I’m not 100% clear of exactly what is in the bootloader, but it does seem to do much more than just load the app

It also initialises the hardware.

After I completely reinstalled all 3 started working normally. Shouldn’t have trusted the OTA

OTA is just so easy to use whitout having to disassemble anything.

I don’t understand how change of the access point made all the problems to surface.

Anyhow. Now the lights are working again!

Thanks!

I remember having issues on UniFi APs (WiFi5) which were resolved by fixing 2.4GHz channels on each of them and trying to get them as little overlapping as possible.

EDIT: If you haven’t, check this document.

Please can you also try the _V4 bin from the nightly to see if that’s any better/different please?