ESPSomfy-RTS: Total crash after remaining in the settings/radio menu

Hardware

ESP32

Firmware version

v2.4.0

Application version

v2.4.0

What happened? What did you expect to happen?

After I have been doing some radio scan tests, I must have forgotten to leave the settings/radio menu.

About an hour later, I wanted to operate a roller shutter by chance and tried to connect again to the WebUI but nothing happened: The controller was “dead”, any HA commands were ignored, not even ping worked. I cannot be sure of the cause of this, but there is at least a temporal connection that would suggest it.

Fortunately, it came back to life after a hard reset (power off) 😃

P.S. I run ESPSomfy RTS since several weeks in ‘productive’ mode without any outages. Sometime, when accessing the WebUI, it hangs for some time; and sometimes a shade, controlled by HA, won’t move, but these have all been self-repairing exceptions so far, this is the first and only total outage.

I find the system very reliable - congratulations and thanks again for this wonderful application! (The commercial Mediola AIO V5 I used before was not more stable, on the contrary, there occured more and more “not-moves” lately, which finally led to the switch to ESPSomfyRTS…)

How to reproduce it (step by step)

1. Go to...
2. Click on...
...

Logs

No response

About this issue

  • Original URL
  • State: closed
  • Created 3 years ago
  • Comments: 25 (11 by maintainers)

Most upvoted comments

Just installed it - After I had disabled the router’s 2.4G channel autochange some weeks ago I didn’t encounter any more outages. And together with your latest optimizations I’m very optimistic that this issue will be finally resolved 😇.

(Anyway - since I’m running several other ESPs, I’ll keep in mind that routers’ channel autochanges in a ‘wifi mesh’ environment is nothing an ESP really seems to like…)