RaspberryNtpServer: Fix for ppstest timeout

With a recent update to Raspbian, it’s necessary to add arm_64bit=0 to /boot/config.txt and reboot in order to get the pps working

About this issue

  • Original URL
  • State: open
  • Created 3 years ago
  • Comments: 43 (15 by maintainers)

Most upvoted comments

I moved the active GPS antenna to a better location, and it’s working now. (I still haven’t figured out how to get the antenna status from the GPS, though; the listed instructions don’t appear to work with minicom.)

Now all I have to do is figure out a better mounting strategy for the Pi and its extremely fragile GPS antenna connector.

after I’m fully manuly upgrade to PiOS lite Bookworm (follow this guide: https://gist.github.com/jauderho/6b7d42030e264a135450ecc0ba521bd8)

and i delete the bcm2708.pps_gpio_pin=4 at /boot/firmware/cmdline.txt (the cmdline.txt and config.txt looks move to /boot/firmware at bookworm)

now it work normally

Just to make sure:

You know that in addition to the USB connection, you need to solder a cable to Adafruit’s PPS output pin and connect that to Raspberry GPIO Pin 4?

(Sorry, I just want to make sure that connection is ok)

I’ve updated the documentation, thanks for your research @aGGreSSiv !

I watched this video. But when I watched it from my current perspective, I realized that I needed to change my google search.

dtparam=uart0=on"

As a result of my searches, only the above command was found in /boot/firmware/config.txt. When you delete this and write it as follows, it says ttyAMA0 instead of ttyAMA10 in front of the serial port. GPSmon works now.

dtoverlay=
dtparam=uart0
dtparam=uart0_console

image

Thank you for guiding me on the right perspective or what I should focus on.

@ZogKarndon
some of my /boot/fireware/config.txt:

[all]
auto_initramfs=1
enable_uart=1
dtoverlay=pps-gpio,gpiopin=4
hdmi_enable_4kp60=1

and my /boot/fireware/cmdline.txt:

console=tty1 root=PARTUUID=50cc6c23-02 rootfstype=ext4 fsck.repair=yes rootwait  cgroup_enable=memory cgroup_memory=1

and if you not get 3D-Lock yet you will recive time_pps_fetch() error -1 (Connection timed out) too, might be check cgps

Thank you @Nebulosa-Cat for this information! I will update the guide.